Norton ghost 15 windows server 2008
- #Norton ghost 15 windows server 2008 how to#
- #Norton ghost 15 windows server 2008 full#
- #Norton ghost 15 windows server 2008 windows#
Your server has room for spare disks, right? Unless the original disk is defective, I leave the old system disk in the server and just move the data to the new drive. Run: bcdedit -store C:\boot\BCD -enum and take note of the "identifier" line in the "Windows Boot Loader" section. Imagex /apply Z:\MyServer-BootPartition.wim 1 C:\ imagex /apply Z:\MyServer-SystemPartition.wim 1 D:\ Write the images to the drive partition (covered in the last post, but repeated here for clarity):
#Norton ghost 15 windows server 2008 windows#
The letters you assign in this step will not effect the letter assignment when windows boots, that's in the registry. Note: If you pick different letters than C and D above, substitute those letters in the following steps as well. Sel drive 0 clean create part pri size=100 format quick act assign letter=c create part pri format quick assign letter=d exit Imagex /capture C:\ Z:\MyServer-BootPartition.wim "MyServer" imagex /capture D:\ Z:\MyServer-SystemPartition.wim "MyServer" Pop the old drive back in the server, and use imagex to grab both the Boot Partition (C:) and the System Partition (D:) (you'll have to run it twice to get both partitions, don't write both to the same WIM file, the second time will just overwrite the first). Unfortunately this is a possibility in Server 2008 that I didn't cover in my previous post, my apologies if this is the case. When you booted WinPE did it show both a C: and a D: drive? If so, keep reading. This is the default for Windows Server 2008 R2 and Windand Vista it depended on if you enabled BitLocker, and which direction the wind was blowing that day. The bootmgr and BCD may have been on a different partition when you used imagex to make a backup. Now can somebody suggest me another way to move Windows Server 2008 to a new hard disk? Is it at least possible to do, or any hard disk failure/change implements necessarily to reinstall the whole OS? When booting from Windows 2008 installation disk (from USB), it finds that the HDD is not bootable and proposes to fix this, but then crashes, resulting in an unbootable USB flash disk (and HDD stays unbootable).Īs I said in my previous question, doing a clone of a hard disk drive gives an (of course) bootable disk, but Windows complain about hardware changes and cannot start.
![norton ghost 15 windows server 2008 norton ghost 15 windows server 2008](https://rmprepusb.com/rmprep/make-a-bootable-ufd-using-symantec-recovery-disk/145f1ad79267b67dab1d2c20b455c156.jpg)
#Norton ghost 15 windows server 2008 full#
Trying the netsh interface ipv4 set address does not work neither (saw at least three different errors, mostly " The interface is unknown.") Solved, but then I have " The parameter is incorrect." error which I have even after removing all old backups, clearing all logs and doing a new full backup.Ī previously suggested solution using imagex from Windows AIK results in a non-bootable disk after writing an image to it.
![norton ghost 15 windows server 2008 norton ghost 15 windows server 2008](https://i0.wp.com/keys4pc.com/wp-content/uploads/2021/03/Norton_Ghost.jpg)
This results in " The parameter is incorrect.
#Norton ghost 15 windows server 2008 how to#
A few weeks ago, I already asked how to move a Windows Server 2008 to a new hard disk.